A key is required to encrypt and decrypt the data. Enhanced Send Diagnostic functions for Wrap Test and write dump to flash. Ultrium tape drives do not read from or write to tape cartridges, and tape drives do not read or write to Ultrium tape cartridges. The drive will not unload an invalid cartridge 2C Do not forward RES when not ready.
|Date Added:||17 May 2007|
|File Size:||40.40 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Added a function which will indicate that the VPD was successfully updated after the library set Mode Page 0Eh and sub page Ultrium tape drives do not read from or write to tape cartridges, and tape drives do not read or write to Ultrium tape cartridges. Some data management applications are capable of performing key management.
IBM LTO Ultrium 3h Internal Tape Drive
How a key is generated, maintained, controlled, and transmitted depends on the operating environment where the Ultrium 4 or later tape drive is installed. Do not forward RES when not ready. Speed matching dynamically adjusts the drive’s native uncompressed data rate to the slower data rate of a server. A parameter, byte 14h, is treated as reserved incorrectly, resulting in command being rejected The Following mode page data is not set to the default value after SCSI Reset: To enhance library performance, Ultrium 2 and newer Ultrium tape drives include speed matching, channel calibration, and power management.
Setting or changing a drive’s method of encryption. Document information More support for: Cartridge is unexpectedly ejected: Check on new hardware Improved tape handling after error: Power management reduces the drive’s power consumption during idle power periods. Drive fails to increment frame number during ADI error recovery correctly.
This means that you can load WORM-capable firmware on your Ultrium 3 and newer tape drives and use any media that are supported by these drives. Check here to start a new keyword search.
IBM LTO Ultrium 3h Internal Tape Drive | eBay
You can identify the Ultrium 1 tape drive by the label at the rear of its canister. For node cards in model xx2 frames, this requires an xx3 model conversion OR the enhanced node card s feature FC or See you tape product’s web page for guidance.
Mixing drives in frames. To perform encryption, the drive must be encryption enabled by your selection of one of three methods of encryption management. Move medium timeout due to bus hang condition.
A key is required to encrypt and decrypt the data. Drive getting wrong write pass value after recovered servo error.
You can identify all Ultrium 2 and later Ultrium tape drives by the logo at the front of the drive or by the label at the rear of the drive’s canister. Add skew check during ultruim initialization and reject write operation if skew is large When the response of LUN1 command is returned, the code, incorrectly, reset the ILI sense existing flag Need to have TA accessible when library door is open When ECC is severely stressed an invalid C2 correction could occur resulting in a read permanent error MTR Failure when between lock and mount position Added support for new Persistent Reserve functions: Could result in interface failure in the field.
FSC 78B5 is being reported even after the cartridge is ejected.
IBM LTO Ultrium 3-H 23R /GB SAS Internal – Datland Technologies, Inc.
Not Applicable Operating system s: LTO bar code label. LUN1 sense data reports additional length of 46h. They also write to tapes that can be read by non-IBM 33 drives. An Ultrium 3 write-once-read-many WORM -capable drive can be identified by the level of code it contains. Mixing media in drives.
Relevel of Fibre Channel code to pick up numerous fixes. Drive continues to load even if the cartridge is removed during the load attempt.